Underground v2.5 by MCM Mods Philippines Resin (6)

Dragon's Den Is Proud To Present The Newly Upgraded Underground Series v2.5 w/ Pure Silver Button Contact by MCM Mods Philippines. The Are The Same High Quality That You Would Expect From MCM But These Have Silver Plated Internals, Which Is Sure To Make These Hit Harder Then They Did Before. And Remember It's Not Safe To Fire Any Series Mod Below .3ohm So Be Careful, I Wouldnt Want You To Blow Yourself Up!!!

*series connection
*with batt adaptor for single battery option
*hybrid 510 connector
*derlin/brass switch
*derlin body
*brass internals
*ss plates on each side
*serialized
*H73mm x W24mm x L50mm
*made in the Philippines

These Mods Can Be Set Up 3 Different Ways!!!

 

 

SERIES MODE WITHOUT HEAT SINK^^^
1. Unpack your UGBox. It should includes the heat sink, derlin spacer and battery adaptor.

2. Unscrew your firing button and 510 hybrid atty adapter.
...
3. Insert batteries. Highly recommended to follow this battery directions:
Positive(+) end should be for your atomizer adapter. 
Negative(-) end should be for your firing button end.
***Please avoid to put batteries on the same end. It may cause your batteries to short and we do not want happening.***

4. FIRST, screw back the firing button in the battery hole with the negative end. Make sure its nice and tight.
SECOND, place and screw the atty adapter on your atomizer, making sure the tip of the bottom positive pin slighly appears.
THIRD, screw your atty and adapter back in place. 

5. Test the firing button. Once tested, you can now enjoy and vape on.

WARNING: its a powerful little piece. Please vape with care.

 

 
SERIES BATTERY MODE WITH HEAT SINK
1. Unscrew your firing button and 510 hybrid atty adapter.
Insert batteries. Highly recommended to follow this battery directions:
Positive(+) end should be for your atomizer adapter. 
Negative(-) end should be for your firing button end....
***Please avoid to put batteries on the same end. It may cause your batteries to short and we do not want happening.***

2. Screw on your favorite attomizer in the heat sink.

3. Another easy one. Screw on the heat sink in the atty adapter.

4. FIRST, more screwing. Screw back the firing button in the battery hole with the negative end. Make sure its nice and tight.
SECOND, place and screw the atty adapter on your favorite atomizer, making sure the tip of the bottom positive pin slighly appears.
THIRD, screw your atty and adapter back in place. 

5. Test the firing button. Once tested, you can now enjoy and vape on.

WARNING: its a powerful little piece. Please vape with care.
 

 

SERIES MODE SINGLE BATTERY WITHOUT HEAT SINK

1. Unpack your UGBox. It should includes the heat sink, derlin spacer and battery adapter.

2. Insert battery and battery adapter. TAKE NOTE:...
Your battery adapter SHOULD ONLY be for your atomizer
Negative(-) end SHOULD ONLY be for your firing button end.
***Please avoid to put batteries on the same end. It may cause your batteries to short and we do not want happening.***

3. Screw back the firing button in the battery hole with the negative end. Make sure its nice and tight.
Place and screw the atty adapter on the battery hole with the battery adapter. 

4. Place your atomizer and make sure the bottom pin connects to the battery adapter. Use the derlin spacer if there is a gap between.

5. Test the firing button. Once tested, you can now enjoy and vape on.

WARNING: its a powerful little piece. Please vape with care


Underground v2.5 by MCM Mods Philippines Resin (6)
Click To Enlarge
Price $180.00
Sale Price $149.99
Availability Not Available
Reviews (0) Write a Review
No Reviews. Write a Review